- Category Tags
- Product Type
- Pumps > Three-screw
- Related Industries
- General Industry
- Pressure Inlet
- Maximum: 1bar-d
- Pressure Discharge
- Maximum: 300/500bar-d
- Fluid Temperature Range
- Maximum: 500°F
- Maximum: 3300ft³/h
- 11mm²/s to 43200mm²/s
- Construction Features
- Design Types
- base plate
- horizontal, vertical, dry
Product DescriptionThree-Screw pump Double Suction up to 20 bar
Series 323F is a double suction design providing the highest flow rates of any three screw pump. They are found in tank farm services, loading and unloading terminals, power plants and asphalt process and transfer.
Nominal flow rate, GPM/LPM, at 300 PSI (20.7 BAR), 200 SSU (43 CST)
Series 323F Specifications
Casing- High tensile gray cast iron. Optional steel casing available. A 150 PSIG (10.3 BAR) steam/hot oil jacket available on steel cased pumps.
Rotor Housing- Cast gray iron.
Power Rotor- Alloy steel.
Idler Rotors- Pearlitic ductile (nodular) iron.
Gaskets- Cellulose and non-asbestos fiber.
Seal & Bearing- Type P: Alternate rows of hard and soft square molded packing rings. Type B: Buna N bellows mechanical seal with carbon on niresist faces. Type H: Positive drive mechanical seal with carbon on niresist faces. Recommended for residual and crude oils. All types have two internal sleeve bearings.
Accessories- Completely mounted, built to order pump/driver assemblies are available with baseplates, ANSI RF spool pieces, etc.
Outlet Pressure- 300 PSIG (20.7 BAR) maximum. Minimum recommended differential pressure is 40 PSI (2.8 BAR). Consult Imo Pump for higher pressures.
Inlet Pressure- 25PSIG (1.7BAR) maximum.
Viscosity- Type P: 100 to 25,000 SSU (20 to 5400 CST). Type B: 50 to 3000 SSU (8 to 650 CST). Consider cold startup conditions. Type H: 50 to 20,000 SSU (8 to 4300 CST). Consult Imo Pump for lower or higher viscosity operation.
Temperature- Type B: 0 to 180°F (-18 to 82°C). Type H and P: 0 to 250°F (-18 to 121°C)
Drive- Direct only.
Rotation- Clockwise facing pump shaft .
Mounting- Horizontal foot mount Optional vertical mounting available for certain applications.
Filtration- Inlet strainers are required to keep contaminants and abrasives out of the pump. They must be selected in consultation with the strainer vendor to prevent pump starvation. Normally, 60 mesh (0.01 inch- 238 micron) for light and 1/8-3/16 inch (3-5mm) openings for heavy oils are recommended.
Maximum Speed*- 1200 RPM
* Assumes minimum inlet pressure requirements are met.
Inquire About This Product
Fill out the form below for information about this product or to learn more about our brand.